3D print lab - Planetary Annihilation

Discussion in 'Planetary Annihilation General Discussion' started by zhaii, March 15, 2015.

  1. zhaii

    zhaii Active Member

    Messages:
    134
    Likes Received:
    48
    *This is the re-envisioning of the previous thread found here.
    https://forums.uberent.com/threads/3d-printing-pa.61517/

    Hey everyone, I'm back with some more PA prints, and I'm armed with videos this time!

    Each video will have the extraction and support process, as well as a time lapse and post processing procedures.

    First off we have the Bolo.



    And I also did a the Cybran T1 Point Defense for the Supreme commander community, so I figured I would share that here too, since the games have a lot to do with each other.

  2. theseeker2

    theseeker2 Well-Known Member

    Messages:
    1,613
    Likes Received:
    469
    +1 for bolo (not ant)
  3. killerkiwijuice

    killerkiwijuice Post Master General

    Messages:
    3,879
    Likes Received:
    3,597
    ant4lyf
    optimi, squishypon3 and stuart98 like this.

Share This Page